Define project criteria for specification compliance checking of cast in place closure joints used with spliced girders.

‍NOTE: These parameters use used by PGSplice only.

The parameters on this tab are allowable stress limits. They can be set to match or deviate from AASHTO.

Stress Limits for Temporary Stresses before Losses (LRFD 5.9.2.3.1 and 5.12.3.4.2d) (pre-2017: 5.9.4.1 and 5.14.1.3.2d)

The information in this section allows you to deviate from LRFD 5.9.2.3.1 and 5.12.3.4.2d

Item	Description
Compressive Stress	Enter the coefficient for the allowable compressive stress.
Tensile Stress in the Precompressed Tensile Zone - In areas without minimum bonded auxiliary reinforcement	Enter the coefficient for the allowable tensile stress.
Tensile Stress in the Precompressed Tensile Zone - In areas with minimum bonded auxiliary reinforcement	Enter the coefficient for the allowable tensile stress.
Tensile Stress in other areas - In areas without minimum bonded auxiliary reinforcement	Enter the coefficient for the allowable tensile stress.
Tensile Stress in other areas - In areas with minimum bonded auxiliary reinforcement	Enter the coefficient for the allowable tensile stress.

‍NOTE: See Longitudinal Reinforcement in the Technical Guide for discussion describing how longitudinal reinforcement in the girder factors into the determination of the allowable tensile stress.

Stress Limits at Service Limit States after Losses. LRFD 5.9.2.3.2 and 5.12.3.4.2d (pre-2017: 5.9.4.2 and 5.14.1.3.2d)

The information in this section allows you to deviate from LRFD 5.9.2.3.2 and 5.12.3.4.2d.

Item	Description
Compressive Stress (Effective Prestress + Permanent Loads)	Enter the coefficient for the allowable compressive stress.
Compressive Stress (Effective Prestress + Permanent Loads + Transient Loads)	Enter the coefficient for the allowable compressive stress.
Tensile Stress in the Precompressed Tensile Zone - In areas without minimum bonded auxiliary reinforcement	Enter the coefficient for the allowable tensile stress.
Tensile Stress in the Precompressed Tensile Zone - In areas with minimum bonded auxiliary reinforcement	Enter the coefficient for the allowable tensile stress.
Tensile Stress in other areas - In areas without minimum bonded auxiliary reinforcement	Enter the coefficient for the allowable tensile stress.
Tensile Stress in other areas - In areas with minimum bonded auxiliary reinforcement	Enter the coefficient for the allowable tensile stress.

Allowable Concrete Stress at Fatigue Limit State (LRFD 5.5.3.1)

The information in this section allows you to deviate from LRFD 5.5.3.1.

Item	Description
Fatigue I plus one-half the sum of effective prestress and permanent loads	Enter the coefficient for the allowable compressive stress.