|
PGSuper
6.0
Precast-prestressed Girder Bridges
|
|
PGSuper
6.0
Precast-prestressed Girder Bridges
|
Three methods of structural analysis for precast prestressed girder brides composed of simple spans made continuous are available. Bridges may be designed as a series of simple spans, simple spans made continuous, or for the envelope of these two conditions.
Guidance and requirements for the design of continuous bridges is given in LRFD 5.12.3.3 (pre-2017: 5.14.1.4)
When the Simple Span and Envelope analysis option is used, the requirements of LRFD 5.12.3.3 are not required to be satisfied (see LRFD 5.12.3.3 (pre-2017: 5.14.1.4))
When the Simple Spans Made Continuous analysis option is used, the requirements of LRFD 5.12.3.3 (pre-2017: 5.14.1.4) are required to be satisfied.
Restraint moments are not computed. Restraint moments can be computed by any method deemed appropriate by the engineer and modeled in PGSuper with user defined concentrated moments.
No assumptions are made about the age of the girder when continuity is established. You'll have to take this into account when determining restraint moments.
For bridges with fully effective connections, continuity can be accounted for in the Strength and Service Limit States. For partially effective connections, continuity can only be accounted for in the Strength Limit State.
A connection is considered fully effective if the calculated stress at the bottom of the continuity diaphragm for the combination of superimposed permanent loads, creep, shrinkage, and 50 percent live load is compressive. This is consistent with the first bullet paragraph in LRFD 5.12.3.3.5.
The top of the precast girders at interior supports are designed as reinforced concrete members at the strength limit state. In this case, the stress limits for the service limit state do not apply to the top of the girders near interior supports.
Negative moment capacity is evaluated at interior supports at the strength limit state.
This provision is not evaluated.
1.8.16