Define the details of a spliced girder.

Segments

From the drop down list, select if using the same segment type for each girder individually or a single segment type for the entire bridge.

When the segment type is defined for each girder individually, select the segment type from the drop down list. The segment types in the list are taken from the Girder library.

The segment grid lists the segments and closure joints that make up the girder. Press [Edit] to edit the details of these components.

Field Installed Tendons

Define the geometry of the post-tensioning ducts for field installed girder tendons

‍NOTE: Girder tendons differ from Segment Tendons

‍NOTE: Be careful to ensure longitindal reinforcement, pretension strands, and post-tensioning ducts do not conflict. Geometric conflicts are not automatically detected.

Item	Description
Duct Grid	Grid listing the general parameters of the ducts and tendons. See Duct Grid below for details.
Duct Material	Select the duct material. Used for evaluation the provisions of LRFD 5.4.6.1. This setting does not effect the duct friction factor or wobble coefficient. Select Project > Losses to edit duct friction factors.
Strand Size	Select the tendon strand size
Installation Method	Select the strand installation method. Used to evaluate the provisions of LRFD 5.4.6.2

Duct Grid

Enter the following information in the duct grid. The first two items define the duct geometry. The remainder of the items define the tendon and the jacking force parameters.

Item	Description
Type	Select a duct type from the drop down list. The duct types are defined in the Ducts library
Shape	Select the shape of the duct. Press [Edit] to edit the details of the duct geometry.
# Strands	Enter the number of strands in the tendon
Pjack	Check the box to enter a jacking force, otherwise the maximum jacking force is used
Jacking End	Select the live end for tendon jacking.
Event	Select the event when the tendon is stressed

Condition Factor

Select the condition of the girder from the drop down list. If "Other" is selected, enter the condition factor.